Product Categories
Contact Us

YUEQING HONGJI CO., LTD.

Add: Room 202, Building C, Jinxiu District, Yueqing,Zhejiang, 325600, China.

Contact: Tinkle Zhu

Mob: +8613736393080

Tel: +86-577-61588229

Fax: +86-577-61588226

E-mail: sales@hkcontrol.cc


Web link: www.hkcontrol.cc

120Vac Ceiling Mount Occupancy Sensor Power Pack Supply 24VDC

Model: MPP-24 Description: 20Amp Power Pack is the Foundation for any Low Voltage Control System. Such as the MPC-50L, MDC-50L, and other Low Voltage Ceiling Mounted Occupancy Sensor.

Products Specifications:

120Vac Ceiling Mount Occupancy Sensor Power Pack Supply 24VDC1 DETAILS.jpg

The MPP-24 supplies low voltage power to occupancy sensors and other control devices, switching line voltage in response to signals from control devices. The power pack is attached to existing junction boxes or mounted into fixture wiring trays. 

Low voltage wiring should use at least 22-gauge wire. High voltage connections should use at least 14-gauge. Always check local building codes. After initial wiring is completed, check wiring diagrams to verify the power pack is wired correctly. 

Improper wiring can cause damage to the power pack, lighting system, occupancy sensor and other control devices.


MPP-24
Electrical Specifications
Voltage120/230/277VAC, 50/60Hz
Load Requirements
Incandescent20amp @120VAC
Ballast20amp @120/277VAC
Motor1HP@ 120/240VAC
Output150mA @24VDC (with relay connected)
Low Voltage Input
Control ON12-24VDC
Hold ON12-24VDC
Hold OFF12-24VDC
Manual ON(momentary switch required)12-24VDC
Environment Specifications
Operating Temperature0℃ to +55℃
Material Specifications
MaterialABS
Standards & Certifications
Certification/ListingUL
Applicable StandardsUL 244A, Third Edition, and UL 916
Warranty2 Year Limited


Features: 

• Self-contained power supply relay system .

• LED indicator of relay operation for easy verification .

• Convert line voltage to low voltage in various lighting control systems .

• Each power pack can be connected with a maximum of six occupancy sensors.

• Easy Installation Essential Component for Ceiling Mounted Occupancy Sensor.

• Certification UL/CUL Listed


Low Voltage Inputs:

Four+12-24VDC input wires are provided to control the load relay.The inputs may be used in combination or individually,depending on the needs of the application .See the Wiring section for wiring information.

Control ON(Blue)- This input is intended for occupancy sensor input.

Applying 12-24 VDC closes the relay.

Remove the voltage and the relay opems if no other input is holding it closed.

Hold ON (Orange)- This input is intended for timer or panel input.

Applying 12-24 VDC closes the relay.

Remove the voltage and the relay opens if no other input is holding it do sed.

It overrides Control ON input.

Refer to figure 4-Typical Wiring From Power Packs to Motion Sensors

Hold OFF(Brown)-This input is used for timer,panel,BAS or load shed input.

Applying 12-24 VDC opens the relay.

Remove the voltage and the relay can accept any other input.

It pverrides Control ON and Hold On inputs.



          1.JPG



Installation:

WARNING:TURN POWER OFF AT CIRCUT BREAKER BEFPRE INSTALLATING

1.Make sure power has been turned off at the circuit breaker.

2.Connect wires as shown in the wiring diagram,or as showm in the BI-LEVEL CONTROL section

            1.JPG


Installation Notes:

1.Power packs sould be installed in accordance with state,local and national electrical codes and requirnerts.

2.Power packs are designed to attach to exsiting or new electrical endosures with 1/2 inch knockouts

3.Most applications require UL listed,18-22 AWG,3-conductor,Class 2 cable  for low voltage wiring. For plenum-approved cables.

4.Rhe MPP-24 is a Class 2 Output power Supply,suitable for parallel interconnection of up to 6 units maximum.This power pack is UL listed for interconnection of power Sources in accordance with National Electric Code.


2 about us.jpg

3 Certifications.jpg

Q1. What is your terms of payment?
A: We accept TT
.


Q2. What is your terms of delivery?

A: FOB, CFR, CIF.


Q3. How about your delivery time?
A: Generally, it will take 7 to 30 days after receiving your advance payment. The specific delivery time depends on the items and the quantity of your order.


Q4. Can you produce according to the samples?

A: Yes, we can produce by your samples or technical drawings. We can build the molds and fixtures.


4 Related Products.jpg

Hot Tags: 120Vac Ceiling Mount Occupancy Sensor Power Pack Supply 24VDC, China, suppliers, manufacturers, factory, domestic